A tire changer removes a tire from its wheel and installs a replacement. It holds the wheel securely and uses tools to guide the tire bead over the rim. It does not balance the assembly or adjust vehicle alignment.
The main parts of a tire changer
- Bead breaker: separates the tire bead from its seated position on the wheel.
- Wheel holding system: rim clamps or a center-clamping arrangement secure the wheel, depending on the machine.
- Mounting and demounting head: guides the bead during removal and installation.
- Drive system: rotates the wheel or positions tools according to the machine’s design.
- Assist arm: helps control a stiff sidewall and keep the bead in the wheel’s drop center.
The drop center is the recessed portion of the wheel that provides room for the bead during mounting and demounting. An assist arm helps manage bead position; it does not make every tire compatible with a machine.
Where the machine fits into a tire service
The technician first identifies the tire and wheel, checks their compatibility and condition, and locates any tire-pressure monitoring sensor. The tire is fully deflated before bead breaking. After removal, the wheel and tire are inspected and suitable components are prepared for installation.
Mounting, bead seating and inflation must follow the equipment manual and tire and wheel manufacturers’ procedures. Inflation involves stored energy and requires trained operation. This overview explains the equipment; use the model’s operating manual for the actual process.
After mounting, the assembly is normally balanced on a separate wheel balancer before installation on the vehicle.
Three sizes to check separately
| Specification | What to compare |
|---|---|
| Wheel clamping range | Wheel diameter and the specified inside or outside clamping method |
| Maximum tire diameter | The complete tire’s outside diameter, not just the wheel size printed on its sidewall |
| Maximum wheel width | The actual wheel and assembly clearance required by the machine |
Also check wheel weight, wheel construction, protective adapters, reverse-mount requirements and support for the tire types you service.
Choosing features for your workload
Start with your typical jobs: passenger cars, light trucks, low-profile tires or run-flats. Then compare assist equipment, wheel protection, working clearance, air supply and electrical requirements. A large maximum wheel diameter alone does not tell you how well a machine will handle a stiff tire.
Send Olympic the wheel sizes and tire types you work on most often. Include occasional difficult jobs so the equipment selection covers more than the average ticket.
Put the right equipment to work.
Tell Olympic about your vehicles, your space and the work you want to do.